The Arduino Motor Shield allows you to easily control motor direction and speed using an Arduino. By allowing you to simply address Arduino pins, it makes it very simple to incorporate a motor into your project. It also allows you to be able to power a motor with a separate power supply of up to 12v.

Can L293D drive 4 motors?

L293D shield is a driver board based on L293 IC, which can drive 4 DC motors and 2 stepper or Servo motors at the same time.

How do you use the L293D motor driver shield?

Start by plugging the shield on the top of the Arduino. Next, connect power supply to the motors. Although you can connect DC motors having voltages between 4.5 to 25V to the shield, in our experiment we are using DC Motors that are rated for 9V. So, we will connect external 9V power supply to the EXT_PWR terminal.

What is L293D motor driver?

L293D is a typical Motor driver or Motor Driver IC which allows DC motor to drive on either direction. L293D is a 16-pin IC which can control a set of two DC motors simultaneously in any direction.

Where can I use L293D IC?

L293D IC is a typical Motor Driver IC which allows the DC motor to drive on any direction. This IC consists of 16-pins which are used to control a set of two DC motors instantaneously in any direction. It means, by using a L293D IC we can control two DC motors. As well, this IC can drive small and quiet big motors.

How much voltage is L293D?

The L293D is designed to provide bidirectional drive currents of up to 600-mA at voltages from 4.5 V to 36 V. Both devices are designed to drive inductive loads such as relays, solenoids, DC and bipolar stepping motors, as well as other high-current/high-voltage loads in positive-supply applications.

How much power does L293D?

“The L293D is a monolithic integrated, high voltage, high current, 4-channel driver.” Basically this means using this chip you can use DC motors and power supplies of up to 36 Volts, thats some pretty big motors and the chip can supply a maximum current of 600mA per channel, the L293D chip is also what’s known as a …

How do I use the L293D motor driver module?

Place the L293D in the center of the breadboard, with half of the pins on either side of the breadboard. Connect 5V to Enable 1 , Vss , and Vs on the L293D. Connect digital output pins (we’re using 6 and 7) to input 1 and input 2 on the L293D. Connect your Arduino’s GND to both GND pins on the same side of the L293D.

How does the l293d motor shield work?

In this instruction, you learn to work on the L293D motor shield. L293D shield is a driver board based on L293 IC, which can drive 4 DC motors and 2 stepper or Servo motors at the same time. Each channel of this module has the maximum current of 1.2A and doesn’t work if the voltage is more than 25v or less than 4.5v.

How many motors can the l293d handle?

The motor driver: The L293D is a dual-channel H-bridge motor driver that can control two DC motors or a stepper motor at one time. As there are two L293D ICs on the shield, it’s technically capable of controlling a total of four DC motors. This is ideal for two and four-wheel robot platforms.

How many pins does the motor Shield have?

The motor shield breaks out Arduino’s 16-bit PWM output pins 9 and 10 to the edge of the shield, with two 3-pin headers. The servos are powered from Arduino’s onboard 5V regulator so there’s no need to connect an external power source to the EXT_PWR terminal.